What are the faults that occur when the hydraulic power station does not operate normally?

Failure phenomenon 1:

The system pressure is normal, and there is no action in execution components

1. There are faults or replacements in the electromagnetic magnet in the solenoid valve.

2. Limit or sequential device (mechanical, electrical, or liquid -moving) is not working or incorrect, adjust, repair or replace.

3. Mechanical failure exclusion.

4. There is no instruction signal search and repair.

5. The amplifier does not work or is not adjusted, fixed or replaced.

6. The valve does not work adjust, repair or replace.

7. Cylinder or motor loss repair or replacement.

Failure phenomenon 2:

Executive component movement is too slow

1. Insufficient pump output traffic or too much system leakage check, repair or replace.

2. The oil viscosity is too high or too low.

3. The control pressure of the valve is not enough or the yinhohole in the valve is blocked and washed and adjusted.

4. Excessive inspection and adjustment.

5. The amplifier fails or is not adjusted to adjust or replace it.

6. Reverse cleaning, filtering or oil change.

7. Discovery or replacement of cylinder or motor wear.

Failure phenomenon three:

Irregular actions, abnormal stress

1. Mixing air, refueling, exhaust in oil.

2. Unstable instruction signal, search, repair.

3. The amplifier fails or incorrectly adjusts, adjusts, repair or replace it.

4. Sensor feedback failure, repair or replacement.

5. Reverse cleaning, filtering or oil change.

6. Cylinder or motor is severely repaired or replaced.